Manual

4.6 Initializing the RAM
42 768 KF Oven
4.6 Initializing the RAM
On the odd case, the RAM of the Oven has to be initialized. After the RAM initialization, all
values are reset to their standard values. You should therefore document your settings if
possible. Print the following reports:
Parameters <PRINT><PARAM><ENTER>
Configuration <PRINT><CONFIG><ENTER>
RAM initialization
1. Switch off Oven.
2. Switch Oven on again and press key <9> at the same time. The display shows:
diagnose
>RAM Initialization
3. Press key <ENTER>. The display shows:
>RAM Initialization
Select: MODE
Select the part that should be initialized. Try first to initialize the part "Setup" only.
If this doesn't help, reenter into the diagnose (steps 1-3) and select "All".
The selections mean:
Mode Sets default values in key <PARAM>
Config Sets default values in key <CONFIG>
Setup Sets default values in branch "Setup", see page 22.
Assembly Sets default values in branch "Assembly", see page 21.
All Sets default values for all device settings.
4. Press key <ENTER>. The initialization will be carried out. Afterwards the display shows:
diagnose
>RAM Test
5. Leave with <QUIT>.
6. Reenter your configuration data and your parameters.