Manual

2.3 Settings on KF Oven

768 KF Oven

2.3.4 Special settings

>lock

<configuration> OFF

<parameters> OFF

<heater> OFF

<pump> OFF

<valve> OFF

<boat> OFF

Locking keys

Key <CONFIG> (ON, OFF)

Key <PARAM> (ON, OFF)

Key <HEATER> (ON, OFF)

Key <PUMP> (ON, OFF)

Key <VALVE> (ON, OFF)

Key <BOAT IN> and <BOAT OUT> (ON, OFF)

>T controller

init.heat.factor 100 %

add.heat.factor 100 %

Factors for T controller of Oven

The controller is optimized, therefore it normally isn't nec-

essary to change the following factors.

Initial heating factor (0...200 %)

Operative after the sample has been moved into the Oven.

Set a lower value if the temperature is below the nominal

temperature, and much above afterwards.

Additional heating factor (0...200 %)

After the initial heating, the heating is controlled by meas-

urements.

Set a greater value if the temperature is not reached dur-

ing too long a time. In this case, a higher "init.heat.factor"

may also help.

Switch the Oven OFF. Press key <CONFIG>, keep key

pressed and switch the Oven ON again.

CONFIG

+Switching ON