Owner's manual

4.2 Control commands
765 Dosimat
35
Command Explanation Live Notes
AFILL ON Auto fill on Y 4.2.33
AFILL OFF Auto fill off Y 4.2.34
QDISPLAY Query display Y 4.2.35
QVOLUME Query volume (ml) Y 4.2.36
QPOSITION Query piston position Y 4.2.37
QPROGRAM Query program version Y 4.2.38
QMODE Query mode Y 4.2.39
QPBLANK Query blank Y 4.2.40
QPFACTOR Query factor Y 4.2.41
QPSMPL Query smpl Y 4.2.42
QVUP Query rate up Y
1)
4.2.43
QVDOWN Query rate down Y
1)
4.2.44
QAUP Query rate analog up on/off Y 4.2.45
QADOWN Query rate analog dwn on/off Y 4.2.46
QDS VOLUME Query dispensing volume Y 4.2.47
QPIP VOLUME Query pipetting volume Y
1)
4.2.48
QLIM VOLUME Query limiting volume Y 4.2.49
QDL VOLUME Query diluting volume Y
1)
4.2.50
QUNIT Query unit Y 4.2.51
QAFILL Query auto fill Y 4.2.52
1)
Use these commands in mode PIP and DIL only not live, i.e. if Dosimat is ready.
Below, every control command is described in detail:
4.2.1 REM ON
Remote on, live
Remote control on. Entries via keyboard are no more possible, the only accepted
commands come from remote control. Calculations in mode DOS are carried out and
displayed until the Dosimat is in its ready state (≥ 3 s). An eventual result transmission
(QDISP) is terminated before the Dosimat has reached its ready state.
4.2.2 REM OFF
Remote off, live
Remote control off. Entries via keyboard are possible again. With remote control off,
remote control commands are not accepted any more.
Command "I" (Information) is active.