Manual

2.10 Fitting the rear panel

761 SD Compact IC / Instructions for Use 8.761.1043

2.10 Fitting the rear panel

Now refit the rear panel which was removed during installation (Section

2.4). Place the incoming and outgoing cables and tubing at the rear

into the openings in the rear panel.

Figure 12: Rear panel

8 Opening for outlet capillaries

for discharge of eluent, regeneration

and sample solution

9 Opening for inlet capillaries

for supply of eluent, regeneration and

sample solution

10 Opening for detector cable

11 Knurled screws

for fastening the rear panel

Metrohm recommends the following distribution over the openings:

Connection Opening leads to

• Suppressor outlet capillary for eluent ("Waste") 44

• Suppressor outlet capillary for regenerant ("Waste") 46

• Connection capillary 48

• Waste container

• Tubing connection to eluent MPak 23

• Tubing connection to regenerant MPak 23

• Eluent MPak

• Regenerant MPak

• Detector connection cable

• Input

"Detector Block"

Then fit the rear panel, fit the upper 2 knurled screws 11 and firmly

screw all 4 knurled screws 11 tight.

Waste B

Waste A