Manual
1 Introduction
761 SD Compact IC / Instructions for Use 8.761.1043
6
32
Sample loop 1.5 ยตL (6.1825.240)
PEEK sample loop
33
Column connection capillary
PEEK capillary 6.1831.010,
length L = 30 cm
34
Metrosep RP Guard 6.1011.020
Precolumn for protecting the separat-
ing column
35
Connection capillary
PEEK connection capillary between
precolumn and separating column
36
Metrosep A Supp 1 HS separating
column (6.1005.350)
IC separating column
37
Suppressor inlet capillary for elu-
ent ("Eluent")
PTFE capillary, permanently mounted
on suppressor, labelled "Eluent"
38
Suppressor outlet capillary for
eluent ("Detector")
PTFE capillary permanently mounted
on suppressor, labelled "Detector"
39
Inlet capillary to detector block
PEEK capillary, permanently
mounted
40
Detector block 1.732.0420
41
Outlet capillary from detector
block
PEEK capillary, permanently
mounted
42
Suppressor inlet capillary for elu-
ent ("H2O")
PTFE capillary, permanently mounted
on suppressor, labelled "H2O"
43
Suppressor module
44
Suppressor outlet capillary for
eluent ("Waste")
PTFE capillary, permanently mounted
on suppressor, leading to the waste,
labelled "Waste"
45
Suppressor inlet capillary for re-
generant
PTFE capillary, permanently mounted
on suppressor, labelled "H2SO4"
46
Suppressor outlet capillary for
regenerant ("Waste")
PTFE capillary, permanently mounted
on suppressor, leading into the
waste, labelled "Waste"
47
Connection capillary
PTFE capillary 6.1803.030, connec-
tion between pump tubing and injec-
tion valve
48
Connection capillary
PTFE capillary 6.1803.030, connec-
tion between injection valve and
waste container
49
Pump drive of the peristaltic
pump
Drive of the two-channel-peristaltic
pump for pumping sample and re-
generant
50 Pressure screw 6.2744.010
54 PEEK coupling 6.2744.040
55 PEEK coupling 4.455.4500
Coupling for "tubing connection to
MPak"
56 Filter unit PEEK 6.2821.120
61 Pump tubing 6.1826.110 for H
2
SO
4
63 PEEK coupling 6.2744.030
64 Pump tubing 6.1826.110 for sam-
ple
65 PEEK coupling 6.2744.160
with tubing security device
On instrument version 2.761.0520 with automated sample change
with the 766 IC Sample Processor, the aspirating tubing
3
is replaced
by the PEEK capillary tubing
18
(see Instructions for Use 766 IC Sam-
ple Processor) installed on the 766 IC Sample Processor. See Section
2.9. for installation of the 766 IC Sample Processor.