Owner manual

4.3 Systems
761 Compact IC
89
List of program instructions
The following program instructions can be added to the time program
on the
Program subpage:
Instruction Parameter entry Meaning
Valve Inject, Fill
Switch injection valve to "INJECT" or
"FILL" position.
FullScale
50, 250, 1000 µS/cm
Set full scale range to the selected
value.
ICPump on, off
Switch on or off the high-pressure
pump.
Flow 0.2 ... 2.5 mL/min
Set flow rate of the high-pressure
pump to the desired value.
Pmax 0.0 ... 25.0 MPa
Set maximum pressure limit for the
high-pressure pump to the desired
value.
Pmin 0.0 ... 25.0 MPa
Set minimum pressure limit for the
high-pressure pump to the desired
value.
Remote 0, 1, *, p
Set remote output lines 1...8 to the
desired values. For entry of the first
value, enter
1, 0, p or *. For entry of the
other values, move the cursor in front
of the value to be changed and enter
1, 0, p or *.
Program END, RESET
The
END flag can be used to end a
program, especially if the program
time should be longer than the
chromatogram duration. Additional
steps after this flag are not allowed.
The
RESET flag is used to reset the
parameters to the system startup
values.
Suppressor
Switch suppressor module to the
next position.
Peristaltic on, off
Switch on or off the peristaltic
pump.
Remote configuration
On the
Remote configuration subtab user-defined remote commands can
be defined, which can be inserted into a time program.