User Manual

2.1. Keypad
751 GPD Titrino
4
2 Manual operation
2.1 Keypad
6.2132.060
The third functions (inscriptions in the triangle) on the keys of the keypad are used for
formula entry, see page 74.
SILO
–
9
STATISTICS
EP
7
MEAS/HOLD
+
8
USER
SMPL
DATA
PARAMCONFIG
→
↑
←
CLEAR ENTER
↓
STOP
START
QUIT
CARD
/
6
CAL.DATA
*
5
PREP
RS
4
USER METH
)
3
DEF
(
2
C-FMLA
C
1
MODE
;
–
REPORTS
ABC
.
PRINT
MN
0
CONFIG Configuration.
PARAM Parameters.
SMPL DATA Sample data.
STATISTICS ON/OFF switching of statistics calcu-
lations of consecutive determination,
see page 77.
MEAS/HOLD ON/OFF switching of measurements
between titrations and hold during ti-
trations.
SILO ON/OFF switching of silo memory for
sample data, see page 96.
PREP Preselection of dosing units, see page
103.
CAL.DATA Calibration data, see page 94.
CARD Management of memory card, see
page 91.
C-FMLA Calculation values, see page 76.
DEF Formulas, data output, sequence for
TIP, see page 74ff.
USER METH Management of internal method mem-
ory, see page 89.
PRINT Printing of reports, see page 80.
REPORTS Result output.
MODE Mode selection, see page 14.
USER User name, see page 84.
CURVE Switching result/curve display.
←,→ Selection of special values (dialog
marked with ":")
↑,↓ Cursor key for navigation.
CLEAR Clears values, set special values.
ENTER Stores values.
STOP Stops methods.
QUIT Quits inquiries, waiting times, printing.
START Starts methods.
CURVE