User Manual

5.1. Setting up and connecting the instruments
751 GPD Titrino
208
5.1.3 Connection of a printer
A variety of printers can be connected to the RS232 interface of the
736 GP Titrino. If you connect a printer other than one of those men-
tioned below, ensure that the Epson mode is emulated or that it
uses the international character set following the IBM Standard Table
437 and IBM-compatible graphics control characters.
If a balance is connected at the same COM of the Titrino as a
printer, you need the 6.2125.010 + 6.2125.030 Adapters.
Printer Cable Settings on Titrino Settings on Printer
Seiko
DPU-414
6.2134.110 baud rate: 9600
data bit: 8
stop bit: 1
parity: none
handshake: HWs
send to: Seiko
none
Seiko
DPU-411
6.2125.020
+
6.2125.010
baud rate: 9600
data bit: 8
stop bit: 1
parity: none
handshake: HWs
send to: Seiko
Citizen
iDP562 RS
6.2134.050 baud rate: 9600
data bit: 8
stop bit: 1
parity none
handshake: HWs
send to: Citizen
Epson LX-
300
6.2134.050 as above but
send to: Epson
see printer manual
HP Desk Jet
with serial
interface
6.2134.050 baud rate: 9600
data bit: 8
stop bit: 1
parity none
handshake: HWs
send to: HP
HP Desk Jet
with parallel
interface
6.2125.020
+
6.2125.010
+
2.145.0300
Parallel-
Serial-
Converter
baud rate: 9600
data bit: 8
stop bit: 1
parity none
handshake: HWs
send to: HP
see printer manual
ON
1 2 3 4 5 6 7 8 9 10
SSW1
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
DIP02
DIP01
B:
A4 paper
A:
1 2 3 4 5 6