User Manual
3.2 Remote control commands
751 GPD Titrino
165
The identifications Id1...Id3 can be used in formulas as sample-specific calcu-
lation constants C21...C23.
If "no unit" is desired for the unit of the sample size, the blank string must be
entered.
3.2.2.3.2.2.123.123. SSmplData.ON.ONSilo.C.Counter.M.MaxLines read only
SSmplData.ON.ONSilo.C.Counter.F.FirstLine read only
SSmplData.ON.ONSilo.C.Counter.L.LastLine read only
Information on silo memory.
.MaxLines: Maximum possible number of silo lines.
.FirstLine: Lowest valid silo line.
.LastLine: Last occupied silo line.
3.2.2.3.2.2.124.124. SSmplData.ON.ONSilo.E.EditLine.1.M.1.Method up to 8 ASCII characters
SSmplData.ON.ONSilo.E.EditLine.1.I.1.Id1 up to 8 ASCII characters
SSmplData.ON.ONSilo.E.EditLine.1.Id2.1.Id2 up to 8 ASCII characters
SSmplData.ON.ONSilo.E.EditLine.1.Id3.1.Id3 up to 8 ASCII characters
SSmplData.ON.ONSilo.E.EditLine.1.V.1.ValSmpl 6-digits, sign and dec.point
SSmplData.ON.ONSilo.E.EditLine.1.U.1.UnitSmpl up to 5 ASCII characters
SSmplData.ON.ONSilo.E.EditLine.1.C.1.C24 read only
SSmplData.ON.ONSilo.E.EditLine.1.C25.1.C25 read only
SSmplData.ON.ONSilo.E.EditLine.1.Ma.1.Mark read only
etc., up to .255.255
Contents of a silo line.
.Method: Method used to process the sample, from the method memory or
from the card.
.Id: The identifications Id1...Id3 can also be used as sample-specific
calculation constants C21...C23 in formulas.
.UnitSmpl: If "no unit" is desired for the sample size, the blank string must be
entered.
.C24, .C25: Results which have been assigned to C24 and C25.
.Mark: Mark of the silo line: "*"=deleted line, "+"=line which is worked off,
"-"= line which is worked off and not valid for silo calculations
(deleted), "/" last worked-off line, where recalculation can still be done.
Silo lines which have been worked off are "read only".
3.2.2.3.2.2.125.125. SSmplData.ON.ONSilo.D.DelLine $G
SSmplData.ON.ONSilo.D.DelLine.L.LineNum 1...255, OFF OFF
Deletion of a silo line. The line # is deleted with &SmplData.ONSilo.DelLine $G.
If a formerly deleted line is edited again, it becomes valid (function "undelete").
3.2.2.3.2.2.126.126. SSmplData.ON.ONSilo.DelA.DelAll $G
Deletes the entire silo memory. Must be triggered with $G.
3.2.2.3.2.2.127.127. SSmplData.ON.ONSilo.Cy.CycleLines ON, OFF OFF
Silo data cycling.