User Manual

3.2 Remote control commands
751 GPD Titrino
159
List of the methods in the user method memory with the following characteris-
tics:
.Name: Name of the method
.Mode: Mode
.Quantity: Measured quantity
.DosUnit: Buret of the method
.Bytes: Number of bytes of the user memory used by the method
.Checksum: Checksum of the method, see 3.2.2.133.
3.2.2.3.2.2.80.80. MeMemoryCard.RRecall $G
MeMemoryCard.RRecall.NName up to 8 ASCII characters
MeMemoryCard.SStore $G
MeMemoryCard.SStore.NName up to 8 ASCII characters
MeMemoryCard.DDelete $G
MeMemoryCard.DDelete.NName up to 8 ASCII characters
Administration of the method memory of the current directory of the memory
card: load, store and delete methods. The action is carried out, if "$G" is trans-
mitted to the corresponding node.
Do not use blank characters before and after method name!
3.2.2.3.2.2.81.81. MeMemoryCard.CChangeDir $G
MeMemoryCard.CChangeDir.NName up to 10 ASCII characters
MeMemoryCard.CChangeDir.CChecksum $G
MeMemoryCard.CChangeDir.CChecksum.VValue read only
Changing the current directory. The action is carried out if "$G" is transmitted to
the corresponding node.
Do not use blank characters before and after name!
The checksum characterizes the content of the directory.
3.2.2.3.2.2.82.82. MeMemoryCard.CrCreateDir $G
MeMemoryCard.CrCreateDir.NName up to 10 ASCII characters
Delete directory. The action is carried out if "$G" is transmitted to the corre-
sponding node.
Do not use blank characters before and after name!
3.2.2.3.2.2.83.83. MeMemoryCard.DelDDelDir $G
MeMemoryCard.DelDDelDir.NName up to 10 ASCII characters
Delete directory. The action is carried out if "$G" is transmitted to the corre-
sponding node.
Do not use blank characters before and after name!
3.2.2.3.2.2.84.84. MeMemoryCard.BBackup $G
MeMemoryCard.BBackup.NName up to 10 ASCII characters
Backup of the internal memory onto the card. The action is carried out if "$G" is
transmitted to the corresponding node.
Do not use blank characters before and after name!