User Manual

3.2. Remote control commands
751 GPD Titrino
158
.L6 Output: Warning: An activate pulse at L6 output (pin 1) in a submethod sets
an output set to active in TIP to inactive.
.Info: Entry of a message which is written into the display. The sequence
remains in the display with the corresponding message. Continue
with &m $G.
.Prep: Preparation of titrating burette.
.Stirrer: Switching stirrer on/off.
3.2.2.3.2.2.76.76. MMode.P.Parameter.P.Presel.M.MeasMode pH, U, Ipol, Upol, OFFOFF
MMode.P.Parameter.P.Presel.MeasI.MeasInput 11, 2, diff.
MMode.P.Parameter.P.Presel.Ip.Ipol 0...11...±127
MMode.P.Parameter.P.Presel.U.Upol 0...400400...±1270
MMode.P.Parameter.P.Presel.Po.PolElectrTest ON, OFF OFF
MMode.P.Parameter.P.Presel.T.Temp -170....25.025.0...500.0
Parameters for TIP: Selection of the measured quantity for manual measure-
ments in the inactive state, see 3.2.2.2. Selection of the measuring input
(MeasInput) applies to measured quantities pH and U. "diff." means differential
amplifier, see page 215. With Ipol the requests for the polarization current in uA
(Ipol) and .PolElectrTest apply. With Upol the request for the polarization volt-
age in mV (Upol) applies. Entry in steps of 10 mV. .PolElectrTest also applies. If
the test for polarized electrodes is switched on (ON), it will be performed on the
change from the inactive state to an active state. The temperature applies to pH
measurements.
3.2.2.3.2.2.77.77. UUserMeth.F.FreeMem read only
Memory space, available for user methods or silo lines. $Q sends the number
of free bytes, e.g. "4928".
3.2.2.3.2.2.78.78. UUserMeth.R.Recall $G
UUserMeth.R.Recall.N.Name up to 8 ASCII characters
UUserMeth.S.Store $G
UUserMeth.S.Store.N.Name up to 8 ASCII characters
UUserMeth.D.Delete $G
UUserMeth.D.Delete.N.Name up to 8 ASCII characters
UUserMeth.DelA.DelAll $G
Management of the internal method memory: Load, store and delete methods.
An action is performed if "$G" is sent to the corresponding node just after en-
tering the name.
Do not use blank characters before and after method name!
.DelAll: Deletes all methods in the user memory.
3.2.2.3.2.2.79.79. UUserMeth.L.List.1.N.1.Name read only
UUserMeth.L.List.1.M.1.Mode read only
UUserMeth.L.List.1.Q.1.Quantity read only
UUserMeth.L.List.1.D.1.DosUnit read only
UUserMeth.L.List.1.B.1.Bytes read only
UUserMeth.L.List.1.C.1.Checksum read only
for each method