User Manual

3.2 Remote control commands
751 GPD Titrino
147
Parameters for DET, MET, SET, KFT, STAT, DOS, DOC: Stop volume. (With
DOS the default value for .Type is "OFF" and the input range for V is
0...99999.99.)
If an absolute stop volume (abs.) has been selected, the volume in mL is valid.
A relative stop volume (rel.) is dispensed as a function of the sample size:
Stop volume in mL = smpl size
*
factor
The factor is valid.
OFF means that the criterion is not monitored.
3.2.2.3.2.2.21.21. MMode.P.Parameter.S.StopCond.M.MeasStop pH: 0...±20.00, OFF OFF
U: 0... ±2000, OFF OFF
I: 0...200.0, OFF OFF
MMode.P.Parameter.S.StopCond.U.UnitMStop read only
Parameters for DET and MET: Stop when a measured value is reached. Entry
as pH value, in mV (with U and Ipol) and in uA (with Upol). The appropriate unit
can be viewed with .UnitMStop.
OFF means that the criterion is not monitored.
3.2.2.3.2.2.22.22. MMode.P.Parameter.S.StopCond.E.EPStop 1...99, OFF
Parameters for DET and MET: Stop when a certain number of EP's has been
found.
OFF means that the criterion is not monitored.
3.2.2.3.2.2.23.23. MMode.P.Parameter.S.StopCond.F.FillRate 0.01...150, max. max.
Parameters for DET, MET, SET, KFT, STAT, DOS, DOC: Filling rate in the titra-
tion in mL/min. Max. means maximum possible filling rate with the Exchange
Unit in current use.
3.2.2.3.2.2.24.24. MMode.P.Parameter.Sta.Statistics.S.Status ON, OFF OFF
MMode.P.Parameter.Sta.Statistics.M.MeanN 22...20
MMode.P.Parameter.Sta.Statistics.R.ResTab.S.Selected originaloriginal, delete n,
delete all
MMode.P.Parameter.Sta.Statistics.R.ResTab.D.DelN 11...20
Entries for the statistics calculations.
.Status: On/off switching. Requirement for statistics calculations is a valid
assignment, see 3.2.2.9.
.MeanN: Number of individual results for statistics calculations.
.ResTab.Select: Selection of the table for the statistics calculations.
original: Original table. The original table is (again) set up, i.e. any
individual results which have been deleted are reincorporated
in the statistics calculations.
delete n: Single result lines are removed from the statistics calcula-
tion. All results of the corresponding line in the statistics table
are deleted. Specification of the line number in .ResTab.DelN.
delete all: Clear entire statistics table. The results can not be reacti-
vated.