User Manual

3.2 Remote control commands
751 GPD Titrino
141
"Setup", continuation
à .AutoInfo Automatic message for changes 3.2.2.169.
³ Ã .Status Switch AutoInfo on/off ON, OFF ditto
³ Ã .P When mains is switched on ON, OFF ditto
³ Ã .T Titrator infos
³ ³ Ã .R When “ready” ON, OFF ditto
³ ³ Ã .G When method started ON, OFF ditto
³ ³ Ã .GC When start is initiated ON, OFF ditto
³ ³ Ã .S When stopped ON, OFF ditto
³ ³ Ã .B Begin of method ON, OFF ditto
³ ³ Ã .F End of process ON, OFF ditto
³ ³ Ã .E Error ON, OFF ditto
³ ³ Ã .H When “hold" ON, OFF ditto
³ ³ Ã .C Continue after "hold" ON, OFF ditto
³ ³ Ã .O Conditioning OK ON, OFF ditto
³ ³ Ã .N Conditioning not OK ON, OFF ditto
³ ³ Ã .Re Request after start ON, OFF ditto
³ ³ Ã .Si Silo empty ON, OFF ditto
³ ³ Ã .M Entry in measuring point list ON, OFF ditto
³ ³ Ã .EP Entry in EP list ON, OFF ditto
³ ³ Ã .RC Recalculation of results done ON, OFF ditto
³ Ã .C Comport infos
³ ³ Ã .B1 When COM1 sends a report ON, OFF ditto
³ ³ Ã .R1 When COM1 is ready again ON, OFF ditto
³ ³ Ã .B2 When COM2 sends a report ON, OFF ditto
³ ³ Ã .R2 When COM2 is ready again ON, OFF ditto
³ Ã .I Changing an I/O input ON, OFF ditto
³ Ã .O Changing an I/O output ON, OFF ditto
³
à .Graphics Changing the curve output
³ Ã .Grid Grid on curve ON, OFF 3.2.2.170.
³ Ã .Frame Frame on curve ON, OFF ditto
³ Ã .Scale Type of depending axis Full, Auto ditto
³ Ã .Recorder Length of axes
³ ³ Ã .Right Length of meas value axis 0.2...0.5...1.00 ditto
³ ³ Ã .Feed Length of paper drive axis 0.01...0.05...1.00 ditto
³
à .PowerOn RESET (power on) $G 3.2.2.171.
à .Initialise Set default values $G 3.2.2.172.
³ Ã .Select Selection of branch ActMeth,Config,Silo,Calib
³ Assembly,Setup,All ditto
à .RamInit Initialization of working mem. $G 3.2.2.173.
à .InstrNo Device Identification $G 3.2.2.174.
à .Value Input of device identification 8 ASCII characters ditto