Owner manual

5.7.3 Alphabetical instruction list

746 VA Trace Analyzer / 747 VA Stand

5-233

Description The DSWEEP instruction (Dummy Sweep) starts the voltage sweep

defined in the parameters. While measured values are recorded during

the sweep, they are not stored.

U.start

U.end

U.step

t.step

Comments • The electrode type must be defined before the DSWEEP instruction.

Admissible are DME, SMDE, HMDE or RDE.

• The measurement mode must be defined before the DSWEEP

instruction. Admissible are DCTMODE, DPMODE, AC1MODE, AC2MODE or

SQWMODE, but not PSAMODE or CYCMODE.

• With the DSWEEP instruction, the potentiostat always operates in the

operating mode "fast".

• If the final voltage U.end should not be switched off at the end of the

program, enter a suitable standby voltage U.standby in a ØMEAS

instruction.

see also SWEEP, FSWEEP, SSWEEP, DME, SMDE, HMDE, RDE, DCTMODE,

DPMODE, AC1MODE, AC2MODE, SQWMODE