Owner's manual
Table Of Contents
- Table of contents
- Table of figures
- 1 Introduction
- 2 Overview of the instrument
- 3 Installation
- 4 Operation
- 4.1 Fundamentals of operation
- 4.2 Instrument and Program Settings
- 4.3 Program information
- 4.4 Calibration functions
- 4.5 Methods
- 4.6 Determinations
- 4.6.1 Preparing samples
- 4.6.2 Preparing the instrument and the accessories
- 4.6.3 Preparing the determination
- 4.6.4 Starting the determination
- 4.6.5 Cleaning the instrument and accessories
- 4.6.6 Adjusting the method parameters during the determination
- 4.6.7 Stopping the determination manually
- 4.6.8 Status of the live curve
- 4.7 Results
- 4.8 GLP functions
- 5 Handling and maintenance
- 6 Troubleshooting
- 7 Technical specifications
- 8 Conformity and warranty
- 9 Accessories
- Index
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Operation
743 Rancimat
￭￭￭￭￭￭￭￭
65
Evaluate induction time
on | off (Default value: on)
Determination of the induction time (see "Induction time", page 66).
Evaluate stability time
on | off (Default value: off)
Determination of the stability time (see "Stability time", page 67).
Note
If you select this evaluation mode, you always need to calibrate the
conductivity measuring cell beforehand.
Delta Kappa
Conductivity change for the determination of the stability time.
Range
1 ... 400 µS/cm
Options for induction time
Evaluation delay
Waiting time until starting the curve evaluation.