Owner's manual
Table Of Contents
- Table of contents
- Table of figures
- 1 Introduction
- 2 Overview of the instrument
- 3 Installation
- 4 Operation
- 4.1 Fundamentals of operation
- 4.2 Instrument and Program Settings
- 4.3 Program information
- 4.4 Calibration functions
- 4.5 Methods
- 4.6 Determinations
- 4.6.1 Preparing samples
- 4.6.2 Preparing the instrument and the accessories
- 4.6.3 Preparing the determination
- 4.6.4 Starting the determination
- 4.6.5 Cleaning the instrument and accessories
- 4.6.6 Adjusting the method parameters during the determination
- 4.6.7 Stopping the determination manually
- 4.6.8 Status of the live curve
- 4.7 Results
- 4.8 GLP functions
- 5 Handling and maintenance
- 6 Troubleshooting
- 7 Technical specifications
- 8 Conformity and warranty
- 9 Accessories
- Index
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Operation
743 Rancimat
￭￭￭￭￭￭￭￭
57
Opening a selected method and adjusting parameters
Proceed as follows to open the method which is selected in the Control
window and adjust its parameters:
1
Open method
￭ In the Control window, click on the symbol in the required
Block A or B.
The dialog window "Method name" appears.
2
Adjust parameters and save changes
￭ Adjust the parameters (see Chapter 4.5.2, page 60).
￭ Confirm the changes with [Save].
Opening an existing method and adjusting parameters
Proceed as follows to open an existing method and adjust its parameters:
1
Open existing method
￭ In the Control window, click on the symbol
or the menu
item File ▶ Open method....
The dialog window Open method appears.
￭ Click on the required method and confirm the selection with
[Open].
The dialog window "Method name" appears.
2
Adjust parameters and save changes
￭ Adjust the parameters (see Chapter 4.5.2, page 60).
￭ Confirm the changes with [Save].