Owner's manual
Table Of Contents
- Table of contents
- Table of figures
- 1 Introduction
- 2 Overview of the instrument
- 3 Installation
- 4 Operation
- 4.1 Fundamentals of operation
- 4.2 Instrument and Program Settings
- 4.3 Program information
- 4.4 Calibration functions
- 4.5 Methods
- 4.6 Determinations
- 4.6.1 Preparing samples
- 4.6.2 Preparing the instrument and the accessories
- 4.6.3 Preparing the determination
- 4.6.4 Starting the determination
- 4.6.5 Cleaning the instrument and accessories
- 4.6.6 Adjusting the method parameters during the determination
- 4.6.7 Stopping the determination manually
- 4.6.8 Status of the live curve
- 4.7 Results
- 4.8 GLP functions
- 5 Handling and maintenance
- 6 Troubleshooting
- 7 Technical specifications
- 8 Conformity and warranty
- 9 Accessories
- Index
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Operation
743 Rancimat
￭￭￭￭￭￭￭￭
139
Acc. to method
Axis scaling in accordance with the settings defined in the method under
Curve representation (see Chapter 4.5.2.3, page 67).
Autoscaling
Automatic definition of the start and end values of the curve axes.
Manual scaling
Manual definition of the start and end values of the curve axes.
X Start
Start value of the time axis in hours.
X End
End value of the time axis in hours.
Y Start
Start value of the conductivity axis in µS/cm.
Y End
End value of the conductivity axis in µS/cm.
"Extrapolation" tab
On the Extrapolation tab, you can carry out the settings for the extrapo-
lation.