User guide

2 Installation

732 IC Detector / 733 IC Separation Center

4949 Ferrule (6.2620.010)

5050 Pressure screw (6.2620.000)

5151 Capillary

6.2620.020 Steel capillary or

6.1831.010 PEEK capillary

5252 Compression fitting

(6.2744.010)

2.5.3 PEEK connectors

For the connection of 6.1822.010 PEEK capillaries (i.D. = 0.3 mm) or

6.1822.010 PTFE microcapillaries, the 6.2744.010 PEEK compres-

sion fittings are used. Proceed as follows:

1 Mount compression fitting

Slide a compression fitting 5252 (6.2744.010) over the end of the

capillary 5151 to be fastened as shown in Fig. 9.

2 Insert capillary in connection

Push capillary end in the corresponding connection as far as it

will go (to avoid dead volume).

3 Tighten compression fitting

Tighten compression fitting 5252 by hand (never use tools).

50504949 5151 5252

Fig. 9: Connectors for capillaries