User guide

6.1 RS232 interfaces
732 IC Detector / 733 IC Separation Center
175
Object Meaning Entry range/Selection
&Diagnosis Diagnostic tests
³
³
Ã.EEPROMInit Initialize data memory $G
³ À.BlockSelect
³
³
³
³
³
³
³
³
³
³
³
³
³
Selection of blocks to be initialized:
USER All blocks except instrument ad-
justment and instrument number
CONFIG Block &Config
INFO Block &Info
SETUP Block &Setup
ASSEMBLY Block &Assembly
EVENT Block &SelectEvent
METHOD Blocks &Parameter and &Program
ALL All blocks incl. instrument adjust-
ment (security code necessary)
USER, CONFIG, INFO,
SETUP, ASSEMBLY, EVENT,
METHOD, ALL
³
Ã.RunMode Parameters for sequence control
³ Ã.Report Output of a diagnostic report on printer on, off
³ À.Stop Stop after error on, off
³
Ã.RAMTest Check working memory $G
³
Ã.KeyTest Check keypad $G, $S
³
Ã.DisplayTest Check display $G, $S
³
Ã.RSTest
³ ³
³ ³
Check RS232 interfaces
(possible only with 3.496.8480 Test plug,
see section 5.4.6)
³ Ã.RS232 Test of "RS232" interface $G, $S
³ À.ICPump Test of "709 IC Pump" interface $G, $S
³
Ã.IOTest
³ ³
³ ³
Check remote interfaces
(possible only with 3.496.8510 Test plug,
see section 5.4.7)
³ Ã.Remote Test of "Remote" interface $G, $S
³ À.SepCent Test "733 IC Separation Center" interface $G, $S
³
Ã.IntTest Internal hardware test
³ Ã.UcellTest Check voltage generator $G, $S
³ Ã.RangeTest Check range amplifier $G, $S
³ Ã.SenseTest Check sense amplifier $G, $S
³ Ã.DACCoarse Check DA converter for coarse adjustment $G, $S
³ À.DACFine Check DA converter for fine adjustment $G, $S
³
Ã.ExtTest External hardware test
³ Ã.LowpassTest Check low-pass function $G, $S
³ Ã.OffsetTest Check offset $G, $S
³ Ã.PolarTest Check polarity $G, $S
³ Ã.TCoeffTest Check temperature coefficient $G, $S
³ Ã.FreqTest Check frequency $G, $S
³ À.ThermostatTest Check thermostat $G, $S