User guide

6.1 RS232 interfaces
732 IC Detector / 733 IC Separation Center
173
Object Meaning Entry range/Selection
³ Ã.Methods Locking of functions of the <METHOD> key
³ ³ Ã.Recall Locking of the "load" functions on, off
³ ³ Ã.Store Locking of the "store" functions on, off
³ ³ À.Delete Locking of the "delete" functions on, off
³ Ã.Display
³ ³
Locking of the LCD (measured values are no
longer displayed)
on, off
³ À.Remote Locking of all remote lines on, off
³
Ã.AutoInfo
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
Automatic messages on change
Note: While the settings of the AutoInfo branch
are stored after saving with "&Setup.Save",
they are not initialised when the instrument
is switched on again. They do not become
active until one of the settings has been re-
set.
³ Ã.Message
³ ³ ³
³ ³ ³
³ ³ ³
³ ³ ³
Elements of the automatic message:
®
Space (dec 32), !, instrument designation,
message from sub-nodes, date (optional), time
(optional)
¯
Example:
®
!732B”.R;.O”95-10-25 16:30:47
¯
³ ³ À.DateTime Output of date and time of appearance on, off
³ Ã.Error Message "E" on error on, off
³ Ã.Ready
³ ³
Message "R" on attainment of basic status
and on program end
on, off
³ Ã.Stopped Message "S" on stop of a sequence on, off
³ Ã.Wait Message "W" on entry into wait status on, off
³ Ã.PowerOn Message "P" when instrument switched on on, off
³ Ã.Inputs Message "I" on change in an input line on, off
³ À.Outputs Message "O" on change in an output line on, off
³
Ã.Save
³
³
³
³
Saving of all parameters
(without saving the parameters changed by
remote control will be lost when the instrument is
switched off)
$G
³
Ã.InstrNo Instrument number
³ À.Value Serial number 8 ASCII characters
³
À.Interface Interfaces
Ã.OutputAssign Setting of the remote output lines
³ À.RemOut
³
³
Basic settings for remote output lines 1…8 when
instrument switched on:
1=on, low, active; 0=off, high, inactive
00000000…11111111
Ã.InputAssign
³ ³
³ ³
Assignment of the remote input lines
(details, see section 6.2.1)
³ Ã.ProgRS Start/stop program (= <PROG R/S>) 1…15
³ Ã.PumpRS Start/stop 709 IC Pump (= <PUMP R/S>) 1…2…15
³ Ã.FillA Switch injection valve A to "FILL" 1…4…15
³ Ã.InjectA Switch injection valve A to "INJECT" 1…8…15
³ Ã.FillB Switch injection valve B to "FILL" 1…3…15
³ Ã.InjectB Switch injection valve B to "INJECT" 1…12…15
³ Ã.Report Trigger report (=<REPORT> key) 1…5…15
³ Ã.Zero Switch on auto-zero (=<ZERO> key) 1…6…15