User guide

6 Interfaces
732 IC Detector / 733 IC Separation Center
170
Object Meaning Entry range/Selection
³ Ã.Mark Trigger marking signal ---, on
³ Ã.AValve Switch injection valve A ---, fill, inject
³ Ã.BValve Switch injection valve B ---, fill, inject
³ Ã.Suppressor Advance suppressor module ---, step
³ Ã.Remote
³ ³
³ ³
³ ³
Set remote output lines 1…8:
* (leave unchanged), 0 (off, inactive, open),
1 (on, active, 0 V)
VV, 0, 1
³ Ã.ProgRS Start/stop program ---, on, off
³ Ã.PumpRS On/off switching of pump drive ---, on, off
³ Ã.Flow Change flow rate ---, 0.01…5.00 mL/min
³ Ã.Pmax Change maximum shutoff pressure ---, 0.1…50 MPa
³ À.Pmin Change minimum shutoff pressure ---, 0.0…50 MPa
:
À.4 Event 4
Ã.Date Date/time or only time (daily) for event 4 YY-MM-DD HH:MM:SS
À.Action Actions of event 4
: see Event 1
&Zero Start/stop of the auto-zero function $G, $S
À.RefValue Auto-zero ref. value (compensated conductivity) read only
&Marker Triggering a marking signal $G, $S
&Plot Start/stop of the graphics plot $G, $S
À.State Status of the graphics plot: on, off read only
&Print
³
Start/stop of the measured value
printout
$G, $S
À.State Status of the measured value printout: on, off read only
&Info Instrument information
³
Ã.Report Send formatted reports $G
³ À.Select
³
³
Selection of the report all, config, event, method,
method list, param, program,
pump
À.ActualInfo Current information
Ã.Inputs Remote inputs
³ Ã.State
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
³ ³
Status of the input lines of the two remote inter-
faces "733 IC Separation Center" and "Remote" in
byte form
(1=on, low, active; 0=off, high, inactive):
"733 IC Sep. Center " "Remote"
ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
n 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Pin 21 9 22 10 23 11 24 12 21 9 22 10 23 11 24 12
Status
n
n
= −
=
∑
2 2
0
14
15
Example:
1 0 1 0 0 0 1 0 0 0 0 0 1 0 0 1
Status = 2
0
+ 2
2
+ 2
6
+ 2
12
– 2
15
=
= 1 + 4 + 64 + 4096 – 32768 = –28603
read only