User guide

6.1 RS232 interfaces
732 IC Detector / 733 IC Separation Center
169
Object Meaning Entry range/Selection
Ã.Parameter General program parameters
³ Ã.Type Program type: cycle, remote, inject cycle, remote, inject
³ Ã.Cycle Loop program
³ ³ À.No Number of cycles 1…999
³ À.Status Program status: inactive, active, test disabled, enabled, test
³
Ã.Edit Edit program
³ À.Select Selection of program steps (max. 20)
³ Ã.1 Program step 1
³ ³ Ã.Time Time for program step 1 x.x, 0.0…999.9 min
³ ³ À.Action Actions of program step 1
³ ³ Ã.Flag Program flag ---, return, reset, end
³ ³ Ã.FSChange Change full-scale range ---, on
³ ³ Ã.Range
³ ³ ³
Reset measurement range 100, 200, 500 µS/cm,
1, 2, 5, 10 mS/cm
³ ³ Ã.FullScale
³ ³ ³
Reset full-scale range 0.05…100…999 µS/cm,
1…10 mS/cm
³ ³ Ã.Zero On/off switching of auto-zero ---, on, off
³ ³ Ã.Polarity Change polarity ---, +, –
³ ³ Ã.Mark Trigger marking signal ---, on
³ ³ Ã.ValveA Switch injection valve A ---, fill, inject
³ ³ Ã.ValveB Switch injection valve B ---, fill, inject
³ ³ Ã.Suppressor Switch suppressor module ---, step
³ ³ Ã.Remote
³ ³ ³
³ ³ ³
³ ³ ³
Set remote output lines 1…8:
T (leave unchanged), 0 (off, inactive, open),
1 (on, active, 0 V)
V, 0, 1
³ ³ Ã.PumpRS On/off switching of pump drive ---, on, off
³ ³ Ã.Flow Change flow rate ---, 0.01…5.00 mL/min
³ ³ Ã.Pmax Change maximum shutoff pressure ---, 0.1…50 MPa
³ ³ À.Pmin Change minimum shutoff pressure ---, 0.0…50 MPa
³ :
³ À.20 Program step 20
³ Ã.Time Time for program step 20 x.x, 0.0…999.9 min
³ À.Action Actions of program step 20
³ : see Program step 1
³
À.DeleteAll
Delete all program steps
possible only in program status "disabled"
$G
&SelectEvent Events
³
Ã.1 Event 1
³ Ã.Date Date/time or only time (daily) for event 1 YY-MM-DD HH:MM:SS
³ À.Action Actions of event 1 1
³ Ã.FSChange Change full-scale range ---, on
³ Ã.Range
³ ³
Reset measurement range 100, 200, 500 µS/cm,
1, 2, 5, 10 mS/cm
³ Ã.FullScale
³ ³
Reset full-scale range 0.05…100…999 µS/cm,
1…10 mS/cm
³ Ã.Zero On/off switching of auto-zero ---, on, off
³ Ã.Polarity Change polarity ---, +, –