User guide

6 Interfaces
732 IC Detector / 733 IC Separation Center
168
Object Meaning Entry range/Selection
&Methods Methods
³
Ã.FreeMemory Free memory (1…9) read only
³
Ã.Recall Load method $G
³ À.Name Method name 8 ASCII characters
³
Ã.Store Store method $G
³ À.Name Method name 8 ASCII characters
³
Ã.Delete Delete method $G
³ À.Name Method name 8 ASCII characters
³
À.AllDelete Delete all methods $G
&Parameter Parameters
³
Ã.Detector Conductivity detector
³ Ã.Range
³ ³
Measurement range 100, 200, 500 µS/cm,
1, 2, 5, 10 mS/cm
³ Ã.FullScale Full-scale range (operating range) 0.05 µS/cm…1…10 mS/cm
³ À.TempCoeff Temperature coefficient 1.5, 2.5 %/°C
³
Ã.AnalogOut Analog output
³ Ã.Polarity Polarity +, –
³ Ã.Offset Zero point shift in % of full-scale range 0, 10, 50 %fs
³ À.Damping Damping on, off
³
Ã.PlotPara Graphics plot
³ Ã.Autostart Automatic start of graphics plot on, off
³ Ã.Interval Time interval for graphics plot 0.4…1.0…99999 s
³ Ã.TimeScale
³ ³
Time scale (paper speed) 0.1, 0.2, 0.5, 1, 2, 5, 10,
20, 60, 120 mm/min
³ Ã.TLabel Labeling of time axis: relative, absolute rel, abs
³ Ã.StopTime Stop time for graphics plot 1…999 min, off
³ Ã.Left
³ ³
³ ³
Left boundary for conductivity axis –2000…0…2000 µS/cm,
–2000…0…2000 mS/cm,
–2…0…2 S/cm
³ À.Right
³
³
Right boundary for conductivity axis –2000…0…10…2000 µS/cm,
–2000…0…2000 mS/cm,
–2…0…2 S/cm
³
À.Pump709 709 IC Pump
Ã.Flow Flow rate 0.01…0.50…5.00 mL/min
Ã.Pmax Maximum shutoff pressure 0.1…10.0…50 MPa
Ã.Pmin Minimum shutoff pressure 0.0…50 MPa
À.Flowcorr Correction factor for flow rate 0.90…1.00…1.10
&Program Program $G, $S
³