User guide

4.8 Data output
732 IC Detector / 733 IC Separation Center
121
Automatic measured value output
• For the automatic measured value output of measured values at se-
lectable time intervals, ">CONFIG/print meas.value/print crit. =
time" must be selected (see section 4.4.2). When the <PRINT> key
is pressed, the measured value output defined by the parameters
"time interval" and "stop time" is started via the RS232 interval.
The measured value output can always be aborted with <QUIT>.
• Example:
Automatic measured value output with single print
header output (with date and time), run time,
measured value
>CONFIG/printer
id.1 column PRP-X100
id.2 conditioning
print header: once
date&time: on
send to: Seiko
>CONFIG/print meas.value
print crit.: time
time interval 600.0 s
stop time 60 min
date&time: off
732 IC Detector 01104 732.0012 Print header
id.1 column PRP-X100 Identification 1
id.2 conditioning Identification 2
date 1995-10-09 time 14:36:43 Date and time
0.0 109.6 uS/cm Run time, 1
st
meas. value
10.0 125.1 uS/cm Run time, 2
nd
meas. value
20.0 133.9 uS/cm Run time, 3
rd
meas. value
30.0 138.2 uS/cm Run time, 4
th
meas. value
40.0 140.6 uS/cm Run time, 5
th
meas. value
50.0 141.0 uS/cm Run time, 6
th
meas. value
60.0 141.2 uS/cm Run time, 7
th
meas. value