User guide

4 Operation
732 IC Detector / 733 IC Separation Center
94
>CONFIG
>CONFIG/RS settings 709
Settings for RS interface "709 IC Pump"
This RS232 interface is normally used for connection of the
709 IC Pump. However, it can also be used to attach an
external printer if the instrument is appropriately configured in
the Setup program ("operation with 709 = off", see sec-
tion 4.4.1). For detailed information on the RS232 interface,
see section 6.1.
>CONFIG/RS settings 709
connected: printer
printer, off
Connection to RS interface
This inquiry appears only with "operation with 709 = off".
printer Connection of a printer (the RS232 pa-
rameters are displayed).
off No device connected (no RS232 pa-
rameters appear).
>CONFIG/RS settings 709
baud rate: 9600
9600,4800,2400,
1200, 600,300
Data transmission rate (baud rate)
This inquiry appears only with "operation with 709 = on" or
"operation with 709 = off" and "connected = printer".
Data transmission rate in bit/s
>CONFIG/RS settings 709
data bit: 8
7, 8
Data bits
This inquiry appears only with "operation with 709 = off" and
"connected = printer".
>CONFIG/RS settings 709
stop bit: 1
1, 2
Stop bits
This inquiry appears only with "operation with 709 = off" and
"connected = printer".
>CONFIG/RS settings 709
parity: none
none, odd, even
Parity
This inquiry appears only with "operation with 709 = off" and
"connected = printer".
none Parity is not checked.
odd Odd parity.
even Even parity.
>CONFIG/RS settings 709
handshake: HWs
HWs, HWf,
SWchar, SWline, none
Handshake
This inquiry appears only with "operation with 709 = off" and
"connected = printer".
HWs Reduced hardware handshake.
HWf Full hardware handshake.
SWchar Software handshake with character stop.
SWline Software handshake with line stop.
none No handshake.
For detailed information on the handshake, see section
6.1.8.