Specifications

The ECO Euro Ped, ECO Wee Curve and ECO Euro Rad models

have the option to be installed as “Direct Vent” appliances,

thereby drawing all primary and secondary combustion air

from outside the home. Once connected, this direct venting

option ensures the air that is heated within the home, stays in

the home improving efciency and reducing fuel usage.

Note: Connection of the Metro’s direct vent inlet to outside the home

is optional. If not connected these Direct Vent models still offer greatly

improved performance and lower emissions due to the unique pre-

heated air path for all primary and secondary combustion air that

these models consume.

Direct Vent Options

Three “Direct Vent kits” are available to connect the ECO DV

Metro to an air supply from outside the living environment of

the home. The kits available include;

• DV WALL KIT – For installations when the Metro is installed

against an outside wall.

• DV FLOOR KIT– For installations onto a oor which has a free

air supply below it.

• DV CEILING KIT– For installations when the Metro is installed

against an internal wall and on a concrete oor

(DV Ceiling kit goes into the wall cavity, then up inside the wall into

the ceiling cavity, where the air supply is drawn from)

Installing the Direct Vent Option

Remove the rear heatshield from the Metro wood re by

unscrewing the four self tapping screws illustrated in Diagram

3 and proceed as follows;

1. Remove the section of panel illustrated with a “hatch”, from

the mid/bottom section of the rear heatshield. This section

to be removed has been pre-punched and only requires a

few small tabs to be cut.

2. Take the “inlet spigot” supplied in the “Direct Vent kit” and

slide it fully down into position into the brackets provided

on the rear of the rebox.

3. Replace the Metro’s rear heatshield with the four screws

previously removed.

The Metro wood re is now ready for installation once you have

pre-tted the Direct Vent kit into the wall or oor. Full instructions

for this procedure are supplied with the Direct Vent kits.

Inlet spigot

Rear

heat shield

Diagram 3

Direct vent option