Specifications

97
Admin Privilege Commands
Command: set
module
ipgateway
Description: Set the default gateway for a services line card.
Syntax: set module ipgateway <chassis> <module>
[<port> <remote>] <gateway>
Note: Requires the “set module ipapply” command to
initiate.
Example: Console>set module ipgateway 1 2 192.168.1.254
Module IP Gateway Successfully set.
Command: set
module ipmask
Description: Set the network mask for a services line card.
Syntax: set module ipmask <chassis> <module>
[<port> <remote>] <netmask>
Note: Requires the “set module ipapply” command to
initiate.
Example: Console>set module ipmask 1 2 255.255.255.0
Module IP Mask Successfully set.
Command: set
module image
Description: Select the boot or core image file to be used at
start-up. Transfer the file via FTP or a specified
file path.
Syntax: set module image <boot | core> <chassis>
<module> <URL>
Options: URL is either one of the following options:
file://<[path/]filename>
ftp://<username>:<password>@<IP address>
[:<port>]/<[path/]filename>
Note: 1. Only applicable to management modules.
2. If the boot or core image file is located in
the root directory of the target management
card, you may enter only the file name.
Otherwise, enter the path to the file.
3. If the port field is not entered or set to
zero, the default FTP server port is used.
4. Getting a file via FTP will lock you out of
the first system you were connected to.
5. If you have FTP available on your PC, you
can get the image directly by entering the
IP address of your PC in the URL field.