Specifications

Command Line Interface
96
webselect : Use this local IP or the redirect
URL for response to web user.
write : Inhibit remotely connected module
control of local module.
Command: set
module icmp
Description: Set the mode that determines how the module
will respond to end-station ICMP messages.
Syntax: set module icmp <chassis> <module> [<port>
<remote>] <enableAll | disableAll | disable-
Broadcast>
Note: EnableAll enables processing of all ICMP
messages.
DisableAll disables processing of all ICMP
messages.
DisableBroadcast enables processing of only
unicast ICMP messages. It disables
processing of ICMP messages sent to IP
multicast, IP subnet broadcast, and IP
limited broadcast addresses.
Only applicable to services line cards.
Example: Console>set module icmp 1 2 disableBroadcast
ICMP Successfully set.
Command: set
module ip
Description: Set the IP address for a services line card.
Syntax: set module ip <chassis> <module> [<port>
<remote>] <IP address>
Note: Requires the “set module ipapply” command to
initiate.
Example: Console>set module ip 1 2 192.168.1.100
Module IP Successfully set.
Command: set
module ipapply
Description: Apply the settings in IP, IP mask, and IP
gateway for the services line card.
Syntax: set module ipapply <chassis> <module> [<port>
<remote>] <apply>
Example: Console>set module ipapply 1 2 apply
Apply IP, IP Mask, and IP Gateway Successfully set.