Specifications

Command Line Interface
94
enable : Enable module and reflect it in
Admin Status.
fdflowctrl : Full Duplex Flow Control.
ftpdisable : Disable FTP server.
ftpenable : Enable FTP server.
help : Show this message.
icmp : Set how the module will respond to
ICMP.
image : Select boot/core images to be used
at boot time.
ip : The module’s IP address (requires
ipapply command to initiate).
ipapply : Apply the settings in IP, IP Mask,
and IP Gateway for the module.
ipgateway : The module’s Gateway IP address
(requires ipapply command to
initiate).
ipmask : The module’s IP Network Mask
(requires ipapply command to
initiate).
l3capability : The module’s capability to receive/
transmit management IP.
llcf : Link Loss Carry Forward.
mvlan : Management VLAN for the internal
management port.
name : User supplied name (32 characters
maximum).
portfctl : Port capability for Flow Control.
portlbktime : Time in seconds loopback is
enabled.
portllcf : Port capability for Link Loss Carry
Forward.
portmgmt : Port capability to receive
management frames.
redabsel : Select output port A (Primary) or B
(Secondary) for SelectAB mode.
redlink : Send link on unselected port when
in Dynamic Recovery Mode.