Specifications

Command Line Interface
92
Command: set
module
dhcpretries
Description: Set the number of address acquisition retries
before reverting to using the last-known valid IP
address.
Syntax: set module dhcpretries <chassis> <module>
<1-5>
Note: The number of retries must be in the range 1-5;
the default is 3. Only applicable to services line
cards.
Example: Console>set module dhcpretries 1 2 5
DHCP retries Successfully set.
Command: set
module disable
Description: Disable a module, if possible.
Syntax: set module disable <chassis> <module>
Note: Typically this can’t be done.
Example: Console>set module disable 1 6
Module Admin Status can't be modified.
Command: set
module enable
Description: Enable a module.
Syntax: set module enable <chassis> <module>
Note: Typically this can’t be done.
Example: Console>set module enable 1 3
Module Admin Status can't be modified.
Command: set
module
fdflowctrl
Description: Set full-duplex flow control on a 10/100Mbps
line card.
Syntax: set module fdflowctrl <chassis> <module>
<enable | disable>
Note: Not applicable to all 10/100Mbps line cards.
Example: Console>set module fdflowctrl 1 13 disable
FD Flow Control Successfully set.