Specifications

Command Line Interface
90
then this option is not selectable and a read of
this value will always return not selectable.
Example: Console>set module autorevert 1 11 enable
Auto Restore Primary successfully set.
Command: set
module
backpressure
Description: Enable or disable backpressure (half duplex
flow control) on a 10/100Mbps line card.
Syntax: set module backpressure <chassis> <module>
<enable | disable>
Example: Console>set module backpressure 1 14 disable
Backpressure successfully set.
Command: set
module
bootpdisable
Description: Disable the BOOTP server.
Syntax: set module bootpdisable <chassis> <module>
Note: Only applicable to R502-M cards that are
configured for a stack.
Example: Console>set module bootpdisable 1 17
Bootp disabled.
Command: set
module
bootpenable
Description: Enable the BOOTP server.
Syntax: set module bootpenable <chassis> <module>
Note: Only applicable to R502-M cards that are
configured for a stack.
Example: Console>set module bootpenable 1 17
Bootp enabled.
Command: set
module
datarate
Description: Specify the data rate for a multi-rate line card,
or set it to auto-detect the rate.
Syntax: set module datarate <chassis> <module> < (0-
29) | 63>
Options: (0) Any Protocol (CDR bypass)
(1) 44.7360 DS-1
(2) 51.8400 OC-1