Specifications

89
Admin Privilege Commands
Command: set
module
activeos
Description: Select the operating system image (primary or
secondary) that is used at boot time.
Syntax:
set module activeos <chassis> <module> <1 | 2>
Note: Only applicable to services line cards.
Example: Console>set module activeos 1 2 2
Active OS Successfully set.
Command: set
module asset
Description: Set the asset tracking identifier for the module.
Syntax: set module asset <chassis> <module[-
converter]> [<port> <remote>] <asset ID>
Note: Multi-word strings must be placed in quotes.
There is a limit of 32 characters for the asset
identifier. Do not use the following characters: .
: ; & = < >.
Example: Console>set module asset 1 1 750444
Asset ID successfully set.
Command: set
module
autorecover
Description: Set Auto-Recovery on some 10/100Mbps line
cards.
Syntax: set module autorecover <chassis> <module>
<enable | disable>
Note: Auto-Recovery prevents a deadlock when LLR
is enabled on two adjoining 10/100Mbps line
cards.
Example: Console>set module autorecover 1 13 enable
Auto Recover Successfully set.
Command: set
module
autorevert
Description: Set the Auto Restore Primary on a redundant
interface line card.
Syntax: set module autorevert <chassis> <module>
<enable | disable>
Note: This controls the card’s ability to automatically
revert back to the primary port if a secondary
switchover occurs. When the redundant
interface line card’s ModeControl is SelectAB,