Specifications

75
Guest Privilege Commands
8 Entity Insert Enabled 1.3.6.1.4.1.2745.11.3.2.0.1
9 Entity Remove Enabled 1.3.6.1.4.1.2745.11.3.2.0.2
10 Entity Reset Enabled 1.3.6.1.4.1.2745.11.3.2.0.3
11 Power Supply Status Change Enabled 1.3.6.1.4.1.2745.11.3.2.0.4
12 Ethernet Port Link Status Change Enabled 1.3.6.1.4.1.2745.11.3.2.0.5
13 Sonet Port Link Status Change Enabled 1.3.6.1.4.1.2745.11.3.2.0.6
14 Sensor Threshold Enabled 1.3.6.1.4.1.2745.11.3.2.0.7
15 Redundant Switch Over Enabled 1.3.6.1.4.1.2745.11.3.2.0.8
16 Ethernet Remote Fault Alarm Enabled 1.3.6.1.4.1.2745.11.3.2.0.9
17 Ethernet Port Speed Change Enabled 1.3.6.1.4.1.2745.11.3.2.0.10
18 TDM Port Link Status Change Enabled 1.3.6.1.4.1.2745.11.3.2.0.11
19 TDM Remote Fault Alarm Enabled 1.3.6.1.4.1.2745.11.3.2.0.12
20 Enet Port Far End Fault Alarm Enabled 1.3.6.1.4.1.2745.11.3.2.0.13
21 MultiRate Port Link Status ChangeEnabled 1.3.6.1.4.1.2745.11.3.2.0.14
22 Dying Gasp Enabled 1.3.6.1.4.1.2745.11.3.2.0.15
Command:
show trap
destination
Description: Show trap destination information.
Syntax: show trap destination
Example: Console>show trap destination
IP Address Udp Port Status Name Snmp Version
———————————————————————————
100.132.60.194 9162 Active NetBeacon 100.132.60.8 V1
100.132.60.197 9162 Active NetBeacon 100.132.60.12 V2
Command:
show trap help
Description: Display the ‘show trap’ subcommands.
Syntax: show trap help
Example: Console>show trap help
Command Description
—————————————————
destination : Show Trap Destination.
controls : Show Trap Controls.
help : Show this message.