Specifications

Command Line Interface
38
Upgrading from a TFTP Server
To execute software that resides on a TFTP server, do the
following:
A. When asked whether to boot from disk or via TFTP over
the network, select TFTP by typing <T>.
B. Enter the IP address of the TFTP server where corepm.biz
is located.
C. Enter the directory and filename for corepm.biz (e.g.,
\tftpboot\corepm.biz for Windows or /tftpboot/corepm.biz
for Unix).
D. Complete the boot configuration dialog. At the end of the
dialog, continue the boot process by typing <C>. The file
will be executed, but not loaded to disk.
Upgrading from Disk
Continue with the following steps after performing steps 1
through 5 in “Firmware Boot Process Via TFTP.” This section
describes how to transfer the embedded software to the
management card via TFTP.
A. When asked whether to boot from disk or via TFTP over
the network, select disk by typing <D>.
B. Type <Y> when prompted with “Transfer file to disk via
TFTP?”
C. Enter the IP address of the system where corepm.biz
resides.
D. Enter the directory and filename for corepm.biz (e.g.,
\tftpboot\corepm.biz for Windows or /tftpboot/corepm.biz
for Unix).