Specifications

Installation Guide

9. Reboot the management card by issuing the command:

“reset module <chassis> <module>” (e.g., reset module 1

17).

Note: Do NOT use the “reset chassis” command. After

successfully rebooting the management card, you are done.

Both boot.bin and corepm.biz will be running.

Firmware Boot

Process via

TFTP

Continue with the following steps only AFTER copying

boot.bin onto the management card.

The initial boot process provides two options for upgrading

files via TFTP. One option enables you to execute a file that

does not reside on the management card. This method does

not load the file onto the management card. Another option

allows you to transfer the file onto the management card and

then execute it.

1. Copy the corepm.biz file into a directory accessible via

TFTP.

2. Reset the management card.

3. During the initial boot process, hit the <space bar>.

4. Select Modify by typing <M>.

5. Make sure the Ethernet port is enabled, and that the

network interface and hardware parameters are set.

Continue with “Upgrading from a TFTP Server” or

“Upgrading from Disk.”