Specifications

Command Line Interface

Upgrade

Firmware Via

FTP

To load the image file (corepm.biz) and boot code (boot.bin)

via FTP on a local console, do the following:

1. Copy the corepm.biz and boot.bin files into a directory

accessible via FTP.

2. Log on to the console at the administrator or root level.

3. FTP to the system where the corepm.biz and boot.bin files

reside.

4. Set the FTP session into binary mode.

5. Go into the directory that contains the corepm.biz and

boot.bin files.

Upgrading to a major software release (e.g., from version 2.1

to 3.x) requires both files to be updated. For most other

software upgrades, you may download only the image file,

however, Metrobility recommends keeping both files synchro-

nized to the same version.

6. Type “get corepm.biz” and “get boot.bin”.

Note: Do NOT reset or power-down the system while

upgrading software! The file system may go into an unknown

state causing boot failures.

7. Once the download is complete, quit the FTP session.

8. If you downloaded the boot code, type “set module image

boot <chassis> <module> file://[path/]boot.bin” (e.g., set

module image boot 1 17 file://boot.bin).

Note: Do not to interrupt the process.