Specifications

Installation Guide

If you remove the card and insert a new card into its slot, one

of the following occurs:

1. If the part number and hardware switch settings match, the

software switch settings stay the same.

2. If the part number matches but the hardware switch

settings do not, the new hardware switch settings take

precedence. All other software settings remain unchanged.

3. If the part number does not match, all hardware settings

for the new card take precedence and the persistence file

is updated with the new data.

Upgrade Procedures

There are several ways of upgrading the embedded code

This section describes three methods to upgrade the

software.

• Command Line Interface (CLI) via FTP

• BOOT Process (to execute embedded software that does

not reside on the management card, or to transfer

embedded software to the management card via TFTP)

• NetBeacon Management Software

Metrobility does not support storing more than two copies of

corepm.biz. If the Flash File System (FFS) is full, we cannot

guarantee operation. In some instances, a full file system can

corrupt the FFS. If the file system’s limit is approached, a

warning message will appear on the console asking you to

delete unnecessary files.

1.When upgrading software to management cards in a stack, make sure that the same soft-

ware version is installed within that stack (e.g., version 3.1 code cannot be mixed with 3.0.1

code in the same stack).