Specifications

Command Line Interface
34
IP address The IP address of the RADIUS server.
secret The shared secret between the device and
the server (up to 65 characters long).
port number (optional) The UDP port where requests
are sent (default port is 1812)
primary (optional) Specifies that this is the primary
server to use.
When configuring the RADIUS server’s IP address, the R502-
M attempts to verify that the server is available on the
network. If the server is not available, you will be prompted to
accept or reject the entry.
Console>set radius server 10.10.10.1 ok
Warning: Could not verify the existence of a RADIUS server at
10.10.10.1 port 1812
Do you want to accept this configuration? [N]
Authentication can then be enabled using the command:
set radius authentication <scope> [enable | disable]
where:
scope all, telnet, web (FTP and HTTP) or console.
Persistence Data
When a chassis is initially started, the management line card
polls all installed cards and saves their part numbers and
hardware switch settings.
When you change a switch setting via software, the card’s
part number, hardware switch settings and new software
setting are saved.