Specifications

Command Line Interface
26
If you select to load via TFTP, the boot loader poses these
remaining questions:
Transfer file to disk via TFTP? [N] y
IP address of the server to copy file from? [0.0.0.0] 100.132.65.23
Name of the file to transfer? [corepm.biz]
Volume needs formatting? [N]
How long (in seconds) should CPU delay before starting up? [10]
Note: This method of operating system load is primarily for
loading a new operating system version, without deleting the
old version from the system.
Once the configuration is complete, the boot loader displays
your responses in the start-up mode console description. You
can either continue with the boot process or change any
configuration parameters.
NETWORK INTERFACE PARAMETERS:
IP address on Primary LAN is 100.132.60.155
Primary LAN interface’s subnet mask is 255.255.255.0
IP address on Secondary LAN is 100.168.0.1
Secondary LAN interface’s subnet mask is 255.255.255.0
IP address of default gateway to other networks is 100.132.60.1
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
HARDWARE PARAMETERS:
R502-M Mpc850 (Rev 0.1) CPU running at 50 Mhz with 10 Mhz
input clock
DRAM 32 Mbytes
NVRAM 8 Kbytes
FLASH 8 Mbytes
This board’s Primary Ethernet MAC address is 0:10:9f:14:C:12
The Primary Ethernet port will run in Half duplex mode
This board’s Secondary Ethernet MAC address is 0:10:9f:14:C:13
The Secondary Ethernet port will run in Half duplex mode
M7500 BOOTLOADER PARAMETERS:
Stack Position is 1