Specifications

23
Installation Guide
For each of the following questions, you can press <Enter> to
select the value shown in braces, or you can enter a new
value.
NETWORK INTERFACE PARAMETERS:
This board's Primary LAN IP address (0.0.0.0 = RARP, 0.0.0.1 =
BOOTP)? [0.0.0.1]
Management software requires IP protocols (SNMP and FTP)
to work properly. For this reason, the boot loader prompts you
for an IP address. IP addresses can be manually assigned, or
assigned via a RARP or BOOTP server within the network to
which the chassis is connected. If you are configuring an
R502-M as the first chassis in a stack, you must do it
manually.
To set up the system using BOOTP, enter <0.0.0.1> in the
board’s LAN IP address field. To configure the system using
RARP, enter <0.0.0.0> in the board’s LAN IP address field.
If you are configuring the system manually, the following
question is asked:
Subnet mask for Primary LAN (0.0.0.0 for none)? [0.0.0.0]
For the R502-M, you are offered the option of enabling or
disabling the secondary Ethernet port. If you are configuring a
master R502-M for a stack, enter <Y> to enable the port. If
you are configuring a slave R502-M for a stack, you must
enter <N>.
Do you want a Secondary LAN interface? [Y]
If you chose to enable the secondary LAN interface, the same
two questions are repeated for the port.
This board's Secondary LAN IP address (0.0.0.0 = RARP, 0.0.0.1 =
BOOTP)? [0.0.0.1]
Subnet mask for Secondary LAN (0.0.0.0 for none)? [0.0.0.0]