Specifications

Command Line Interface
22
Manual
Configuration
Below is an example of the console display information:
Metrobility Optical Systems Inc. Boot Application : 3.8.0
Executing Power-On Selftest......
———————————————————————————
NETWORK INTERFACE PARAMETERS:
LAN IP address will be obtained from BOOTP
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
HARDWARE PARAMETERS:
R502-M Mpc850 (Rev 0.1) CPU running at 50 Mhz with 10 Mhz
input clock
DRAM 32 Mbytes
NVRAM 8 Kbytes
FLASH 8 Mbytes
This board’s Primary Ethernet hardware address is 0:0:0:0:0:0
The Primary Ethernet port will run in Half duplex mode
This board’s Secondary Ethernet hardware address is 0:0:0:0:0:0
The Secondary Ethernet port will run in Half duplex mode
M7500 BOOTLOADER PARAMETERS:
Chassis is not in a Stack
Name of the Boot image is boot.bin
Boot via the TFTP Bootloader
IP ADDRESS of the TFTP host RARP server
The file to download and start is corepm.biz
RADIUS authentication for the console is not disabled.
RADIUS failure defaults to local authentication is not enabled
Allow Telnet user to execute secure CLI commands is not enabled
After board is reset, start-up code will wait 10 seconds
———————————————————————————
To change any of this, press any key within 10 seconds
(M)odify any of this or (C)ontinue? [M]
Each question that the boot loader poses has a default
response contained within brackets [ ]. If the system has not
been configured, the brackets contain the factory default
values. If the system has been configured, the system saves
the last used values.