Specifications

Command Line Interface
20
Allow Telnet user to execute secure CLI commands is not enabled
After board is reset, start-up code will wait 10 seconds
———————————————————————————
To change any of this, press any key within 10 seconds
(M)odify any of this or (C)ontinue? [M] c
Verifying volume.
If you don’t have a BOOTP server, or if you don’t have a
BOOTP entry for this system, you will see the following
message:
BOOTP request failed: Check for a RARP server/Network Error
If you wish to set up your BOOTP server, you must provide an
IP address, subnet mask, and default gateway. If you do not
wish to use BOOTP, you can hit any key and modify the boot
parameters.
Configuration
of the Boot
Loader
The boot loader can be configured to obtain its image and
configuration information from three different sources:
manually through the boot loader configuration dialog,
through a BOOTP server, or partially configured through a
RARP server.
To configure the boot load type, press any key within the
designated time to access the system configuration menus.