Specifications

Command Line Interface

Manager, HP OpenView for UNIX, HP OpenView for NT,

SNMPc and others. Refer to the Console Commands section

for a detailed description of configuration commands.

The PC Terminal Session Parameters are as follows:

9600 Baud / 8 data bits / 1 stop bit / no parity / no flow control

Power-on Boot

Indications

Following power-up, the boot image is automatically

executed. It starts by performing a system initialization,

followed by diagnostic tests. During this process, the Run

LED is off and the Error LED blinks. After diagnostics are

complete, if a failure has occurred, the Error LED remains on.

The Run LED does not illuminate until the operating system is

successfully started.

Management

Line Card LED

Indicators

LED Name

Label Status Indication

Ethernet Link LK ON LINK present

Ethernet Activity AT ON

LINK present and receiving

packets

Power PWR ON

Management line card is

receiving power

Power Supply A A ON Power supply A is ON

Power Supply B B ON Power supply B is ON

Run R

OFF

Performing diagnostics or

loading OS

Successful OS load and system

operating normally

MGT-10

PWR