Specifications

15
Installation Guide
Chapter 2: Installation
Guide
This section describes how to install the management card
into the chassis, connect to the network and stack, and boot
up for SNMP management.
Safety Warnings
Electrostatic Discharge Warning
Electrostatic discharge precautions should be taken when
handling any line card. Proper grounding is recommended
(i.e., wear a wrist strap).
Battery Replacement Warning
Danger of explosion if the battery on the management card is
incorrectly replaced. Replace only with the same or equiv-
alent type recommended by the manufacturer. Dispose of
used batteries according to the manufacturer’s instructions.
Install the Management Card
The management card must be installed in the slot furthest to
the right of the chassis. You may install it in either slot of a
two-slot chassis. All other line cards may be installed into any
slot.
Follow the simple steps below to install the management
card:
!
!