Specifications

Command Line Interface
140
Location Name Status Duplex Speed Type ANeg LLR Activity Connector
______________________________________________________
1/2-12/1 Port2-12_1 Link Full 10Mb e10BaseFL_SM n/a Enabled Inactive ST
1/2-12/2 Port2-12_2 Link Full 10Mb eBaseT n/a n/a Inactive RJ-45
Set LLR on the fiber port of Fixed Port 8. The fiber port is Port 1.
>set port LLR 1 2-8 1 enable
LLR successfully set.
Set LLCF on Fixed Port 3.
>set mod LLCF 1 2-3 enable
LLCF successfully set.
Persistence for
a Fixed Port
Chassis
When a management card is installed in a fixed port chassis,
the software can be used to override the LLCF/LLR switch
settings. Upon initial boot-up, the management card reads the
position of the LLCF/LLR switches and sets the ports to
match the settings. This information is saved in a persistence
data file.
Following a reboot, the management card reads the position
of the LLCF/LLR switches and compares them to the persis-
tence data file. Persistence works as outlined below.
1. If the switch settings match the settings in the persistence
data file, the software settings will be enforced, and the
persistence data file will be unaffected.
2. If the switch settings do not match because a change was
made, the new hardware switch setting takes precedence.
All other software settings will stay the same.
Pushing any LLCF or LLR hardware switch takes effect
immediately.