Specifications

Command Line Interface
112
back to the sender.
Syntax: set port dislbkres <chassis> <module> <port>
Note: Only applicable to R133-xx cards.
Example: Console>set port dislbkres 2 6 2 disable
Disable Loopback Response successfully set.
Command: set
port duplex
Description: Modify a port’s duplex mode.
Syntax: set port duplex <chassis> <module> <port>
[<remote> <remoteport>] <duplex>
Note: Duplex is either half or full.
Example: Console>set port duplex 2 14 2 full
Port duplex successfully set.
Command: set
port enable
Description: Enable a port.
Syntax: set port enable <chassis> <module> <port>
[<remote> <remoteport>]
Note: This only applies to management, TDM,
services, and access line cards.
Example: Console> set port enable 2 3 2
Admin Status successfully set.
Command: set
port fault
Description: Set the Far End Fault on an access line card or
TDM port. This allows the locally managed card
to detect a break in the remote card’s fiber port
receiver.
Syntax: set port fault <chassis> <module> <port>
[<remote> <remoteport>] <enable | disable>
Example: Console> set port fault 2 3 2 enable
Remote Fault successfully set.