Specifications

111
Admin Privilege Commands
Syntax: set port bert <chassis> <module> <port>
<enable | disable>
Note: Only applies to the fiber port of a T1/E1 line
card. Remote loopback must be enabled
separately if you want the test data returned to
the sender.
Example: Console>set port bert 1 14 2 disable
BERT511 successfully set.
Command: set
port
burstlength
Description: Set the maximum receive or transmit burst size
on an access line card’s copper port. This
allows traffic to flow at line rate until the burst
limit is reached.
Syntax: set port burstlength <receive | transmit>
<chassis> <module> <port> [<remote>
<remoteport>] <16KB | 32KB | 64KB | 128KB |
256KB>
Example: Console>set port burstlength receive 2 11 2 1 1 64KB
Receive Burst Length successfully set.
Command: set
port disable
Description: Disable a port.
Syntax: set port disable <chassis> <module> <port>
[<remote> <remoteport>]
Note: This command only applies to management,
TDM, services, and access line cards.
Example: Console>set port disable 2 3 2
Admin Status successfully set.
Command: set
port dislbkres
Description: Determines the response of the fiber port when
it receives the remote loopback command.
When enabled, the port ignores the remote
loopback command. When disabled, the port
enters remote loopback mode. During remote
loopback mode, data on the fiber port to looped