Specifications

Command Line Interface
110
Command: set
port autoneg
Description: Modify the auto-negotiation status on the
copper port of a card with this feature.
Syntax: set port autoneg <chassis> <module> <port>
[<remote> <remoteport>] <enable | disable>
Note: 1. For a 10/100Mbps card or a chassis stacking
line card, auto-negotiation determines how a
port advertises its speed and duplex capabil-
ities. Auto-negotiation is dependent on both
the speed and duplex switch settings.
2. For an access line card, the copper port
advertises full/half duplex capability when
auto-negotiation is enabled. Speed is always
100Mbps. When auto-negotiation is disabled,
the port operates in full duplex. Auto-negoti-
ation must be enabled if the device
connected to the copper port is set to half
duplex.
Example: Console>set port autoneg 2 10 1 disable
Auto Negotiate successfully set.
Command: set
port bandwidth
Description: Set the receive or transmit bandwidth on an
access line card’s copper port to the specified
bandwidth in 1Mb increments.
Syntax: set port bandwidth <transmit | receive>
<chassis> <module> <port> [<remote>
<remoteport>] <bandwidth>
Note: Bandwidth is any number from 1 to 100.
Example: Console>set port bandwidth transmit 2 11 1 75
Transmit Bandwidth successfully set.
Command: set
port bert
Description: Set the Bit Error Rate Test on a T1/E1 card.
When enabled, the card generates a 511
pattern on the data channel. For normal
operation, this function should be disabled.