Specifications

Command Line Interface
106
Command: set
module
upglocation
Description: Specify the location on the module where the
upgrade server will download the file onto.
Syntax: set module upglocation <chassis> <module>
[<port> <remote>] <FPGA[1|2|S|R|D] |
OS[1|2|S|R|D] | CNFG[1|2] | BOOTLDR>
Note: Only applicable to services line cards.
FPGA or OS: download to the inactive FPGA or
OS location.
FPGA1 or OS1: download to the primary FPGA
or OS location.
FPGA2 or OS2: download to the secondary
FPGA or OS location.
FPGAS or OSS: download to the inactive
FPGA or OS location and set the new
location as active. No change occurs until
the next reset, when the new software will
be activated.
FPGAR or OSR: download to the inactive
FPGA or OS location, set the new
location as active, and then reset the
card. The new software is activated.
FPGAD or OSD: download to the inactive
FPGA or OS location, set the new
location as active, and then reset the card
to its factory default settings. The new
software will be activated only if it is
downloaded to the default location
(primary).
CONFIG1: download a new configuration file/
script into the primary location.
CONFIG2: download a new configuration file/
script into the secondary location.
BOOTLDR: overwrite the existing boot loader
code.
Example: Console>set module upglocation 1 2 OS2
Upgrade Image Location Successfully set.