Specifications

Command Line Interface
104
Note: With SONAR enabled, the module will switch
ports if it detects a loss of activity for two
seconds at the active port, or for the configured
time (0-31 seconds) for a Gigabit redundant
line card. To enable SONAR, the module must
be in Dynamic Recovery mode and redlink
must be enabled.
Example: Console>set module SONAR 1 4 enable
SONAR successfully set.
Command: set
module
telnetdisable
Description: Disable the Telnet server.
Syntax: set module telnetdisable <chassis> <module>
Note: Only applicable to management modules.
Example: Console>set module telnetdisable 1 17
Telnet disabled.
Command: set
module
telnetenable
Description: Enable the Telnet server.
Syntax: set module telnetenable <chassis> <module>
Note: Only applicable to management modules.
Example: Console>set module telnetenable 1 17
Telnet enabled.
Command: set
module
transparent
Description: Allows end points to transparently auto-
negotiate.
Syntax: set module transparent <chassis> <module>
<enable | disable>
Note: Only applicable to R111-13-B, R111-15-B, and
R141 line cards.
Example: Console>set module transparent 1 6 enable
Transparency successfully set.